FDM Part Curl

From: wayne l foss (wlfoss@cacd.rockwell.com)
Date: Mon Jul 06 1998 - 16:41:20 EEST

Next message: Eric Radstok: "Sparx"
Previous message: joshua10@usa.net: "(no subject)"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I have responded to Gautham's FDM part curl problem with a simple
solution that I have discovered. If anyone else is interested, I will
e-mail you a copy.

Wayne

-- 
==============================================================================
- Wayne L. Foss                            wlfoss@collins.rockwell.com
- Engineering Services                     Phone  319/295-2631
- Rapid Prototyping Specialist             FAX  319/295-5429
- MS 106-176
- Rockwell Collins, Inc.	 
- 400 Collins Road, NE             
- Cedar Rapids, IA  52498-3161
------------------------------------------------------------------------------
DISCLAIMER: Unless otherwise indicated, this correspondence is personal
opinion and NOT an official statement of Rockwell Collins, Inc.
------------------------------------------------------------------------------
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Eric Radstok: "Sparx"
Previous message: joshua10@usa.net: "(no subject)"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:09 EEST