Re: Kicking again (The ultimate list)

From: Marshall Burns (marshall@ennex.com)
Date: Sun Jul 05 1998 - 00:09:45 EEST

Next message: Alain BERNARD: "comparison between RP processes"
Previous message: gautham@asu.edu: "Re: artist wants carved styrene shapes"
In reply to: Henri Koukka: "Kicking again (The ultimate list)"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Henri Koukka wrote:

> Hey come on, my friends. I'm sure you can do it better... In my opinion the
> list of methods died too quickly. Maybe we should start it again. If I

Henri,

You could add Ennex Corporation, developing the fabricator to be called the
Genie Studio Fabber, using the process known as Offset Fabrication. Web
address: http://www.Ennex.com/.

Best regards,
Marshall Burns
Marshall@Ennex.com

*****************************************************************
***** ENNEX(TM) CORPORATION
***** Fabbing the Future(TM)
*****************************************************************
***** 10911 Weyburn Avenue, Suite 332, Los Angeles, U.S.A. 90024
***** Phone: +1 (310) 824-8700. Fax: +1 (310) 824-5185
***** E-mail: fabbers@Ennex.com. Web site: http://www.Ennex.com
*****************************************************************
***** Copyright (c) 1998, Ennex Corporation

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Alain BERNARD: "comparison between RP processes"
Previous message: gautham@asu.edu: "Re: artist wants carved styrene shapes"
In reply to: Henri Koukka: "Kicking again (The ultimate list)"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:08 EEST