For everyone's information:
In case you didn't already know, the UNV "save" option is no
longer going to be supported by SDRC in future releases of I-DEAS--I don't
know if they will still read UNV, though. In fact, I think even V 5.0
doesn't support it currently.
Justin
On Fri, 19 Jun 1998, Mauro Orio wrote:
> The conversion from UNV to STL,and it is running very well,is avaiable from CUBITAL
> since 1991.You can contact them for more information about.
>
> Regards
>
> Mauro Orio
> Promau Engineering S.r.l.
> Via per Novara ,155
> 28026 CAMERI (NO) ITALY
> Ph. +39 0348 2258617 Direct
>
-----------------------------------------------------------------------
Justin Kidder, Research Asst. | Automation and Robotics Laboratory
jrkst34+@pitt.edu | University of Pittsburgh
Home page: http://www.pitt.edu/~jrkst34
-----------------------------------------------------------------------
There are two rules for ultimate success in life:
1. Never tell everything you know.
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:00 EEST