To: Justin, Brett, and all the Service Bureaus out there
I am not thinking outside my own box and I apologize.
I was not looking at the problem from the "toss it over the wall"
point of view. I usually have the luxury of interacting with the
engineer/designer myself and this gives me tunnel vision.
I still feel that you should use the actual Modeler data file which
can contain the exact shape, density, color, texture, and material
specification. If you output the contour and material definition to
the machine ( RP Machine specific Print Drivers? ) then the part
produced is only limited by the capabilities of that machine.
Myopia affects us all,
Larry Blasch
System Administrator for Engineering Services
OPW Fueling Components
P.O. Box 405003 Voice: (513) 870-3356
Cincinnati, OH 45240-5003 USA Fax: (513) 870-3338
**********************************************************************
Disclaimer...The views expressed are personal opinion and not those of
OPW Fueling Components.
**********************************************************************
* "Always remember you're unique, just like everyone else." *
**********************************************************************
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:48 EEST