Rajeev Garg wrote:
>
> I am looking for a software to cut the STL files into two or three
> pieces. Is there a demo copy of any easy to use software on the web that
> will do such a job.
>
The basic core module of DeskArtes Rapid Tools software can cut STL
files.
Specific module is called Rapid Editor and it has the following
features:
· Automatic repair of STL files
· Selective gap filling
· Adding, Deleting, and Copying Facets
· Editing STL files
· Cutting of STL files
· Orientation of normals
· Separation of connected components
· Separation at parting lines
· Visualization of STL & IGES files
· Looking inside STL & IGES files
· Scaling STL files
· Positioning multiple STL files
· Dimensioning and Measurement
· Volume & Area Computations
Best regards,
Michael Tsenter
-- DeskArtes - North America a division of NEST Technologies 3849 Ridgemoor Drive Studio City, California 91604Tel: 818-761-6500 Fax: 818-761-6116 e-mail: nest@primenet.com web site: http://www.primenet.com/~nest/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:38 EEST