Machining Silicone rubber

From: Peter Blacklin (blacklin@erols.com)
Date: Thu May 07 1998 - 15:44:59 EEST

Next message: Volker Schillen: "IMPORTANT for all rp'lers with practical experience"
Previous message: Priit Kull: "Re: Pi and Alabama (Off Topic)"
Next in thread: Brandon Ferguson: "Re: Machining Silicone rubber"
Reply: Brandon Ferguson: "Re: Machining Silicone rubber"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Do a rough cut to near size and then grind down to the final profile.

Peter Blacklin
Optimum Solutions Inc.

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Volker Schillen: "IMPORTANT for all rp'lers with practical experience"
Previous message: Priit Kull: "Re: Pi and Alabama (Off Topic)"
Next in thread: Brandon Ferguson: "Re: Machining Silicone rubber"
Reply: Brandon Ferguson: "Re: Machining Silicone rubber"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:33 EEST