Sheetmetal s/w info needed

From: Stavros Zannis (zannis@lms.mech.upatras.gr)
Date: Thu Feb 26 1998 - 10:26:01 EET


Dear list,

I am looking for information on software used for sheetmetal procedures.
Especially, info needed on the handling, nesting/stacking of the laminations.
The software must be PC based.

Thank you in advance

Stavros Zannis
Department of Mechanical Engineering
University of Patras
Greece

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/



This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:00 EEST