0.3 mm Z height problem

• Next message: Jürgen Bauer: "AW: Large prototypes"
• Previous message: Delft Spline Systems: "Re: Pulley prototypes? Stamping Q's"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Re: Joost Mikkers 0.3 mm too high SLA models

The Z height problem is a function of the 'hatch overcure' and 'print
through' it can be reduced by adjusting the hatch overcure and skin fill
cure depth parameters . These can cause other problems if you choose the
wrong values. You should be able to reduce the error to 0.1mm max.

A simpler way is to use Zslice in your Maestro slice options ( Auto Z
correct, ON, 2 layers ).

Jan Andrzejewski
RP Operations Manager
Pera

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

• Next message: Jürgen Bauer: "AW: Large prototypes"
• Previous message: Delft Spline Systems: "Re: Pulley prototypes? Stamping Q's"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:44:55 EEST