RE: SLA builds 0.3 mm too large

From: Stahlhut, Todd A. (stahlht@indy.navy.mil)
Date: Thu Feb 12 1998 - 14:01:00 EET


Are you using maestro 1.8 with the auto Zcorrect option. This option is
under slice options selected from the part pop up menu. We use 1 layer
of correction. Before this most parts were about .01 inch over in Z.
Now they are usually an average of +/- .005 in XYZ. Note that you still
seem to get the odd dimension that ends up out by more, but generally
most fall in this range. May want to look at this.

Regards, Todd Stahlhut
 ----------
From: Joost.Mikkers@NL.DAP.philips.com
To: rp-ml
Subject: SLA builds 0.3 mm too large
Date: Thursday, February 12, 1998 2:19AM

        TO: rp-ml@ltk.hut.fi at #smtp

         Dear RP-ML users,

         We have a SLA 250. The parts built are always
         0.3 mm too high (z-direction), no matter what>
         size the product is. In x-y there is no problem.
         I have a feeling it's in the intersection between
> supports and product. Any suggestions?
>
>
> J.C. Mikkers.
>

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/



This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:44:54 EEST