FDM borders

From: Drew Brown (conreality@greatid.com)
Date: Thu Feb 05 1998 - 01:19:21 EET

Next message: VERN CARTER: "Problems with Autodesk products"
Previous message: David Bourell: "Ian Campbell's Whereabouts"
Next in thread: ralott@CCGATE.HAC.COM: "Re: FDM borders"
Maybe reply: ralott@CCGATE.HAC.COM: "Re: FDM borders"
Maybe reply: Robert Hoffman: "Re: FDM borders"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Has anyone had any difficulties with FDM borders not completely fusing to the previous layer on sloped,
unsupported walls? This problem causes the part walls to look rippled. If anyone has any suggestions to
correct this problem it would be greatly appreciated. We are running an FDM1650 in ABS.

Thanks in advanced.

Drew Brown
Conceptual Reality L.L.C.
Phone:(248)926-8820
Fax:(248)926-8830
http://www.conceptual-reality.com

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: VERN CARTER: "Problems with Autodesk products"
Previous message: David Bourell: "Ian Campbell's Whereabouts"
Next in thread: ralott@CCGATE.HAC.COM: "Re: FDM borders"
Maybe reply: ralott@CCGATE.HAC.COM: "Re: FDM borders"
Maybe reply: Robert Hoffman: "Re: FDM borders"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:44:49 EEST