part orientation(LOM)

From: Stuart Hogarth (stuart.hogarth@unn.ac.uk)
Date: Fri May 16 1997 - 20:12:00 EEST

Next message: Yakov Horenstein: "(Off-topic) - The Hot Seat: Japan's High-Tech Toilets"
Previous message: Yakov Horenstein: "Re: Service Bureau"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

RP'rs and Sadegh

I have done some initial test on our LOM parts.

Tensile results have shown that part strength along the length of the paper
roll(x) is twice that of the part strength across the width(y).

Stress in X = 72 N/mm2
Stress in Y = 36 N/mm2

I have not yet found the machine time to build specimens in Z direction.

Hope this is of interest.

Stuart Hogarth

Researcher
Centre for Rapid Product Development (CRPD)
University of Northumbria at Newcastle
Ellison Building
Ellison Place
Newcastle upon Tyne
NE1 8ST
United Kingdom
stuart.hogarth@unn.ac.uk
http://www.unn.ac.uk/~mfx2

Next message: Yakov Horenstein: "(Off-topic) - The Hot Seat: Japan's High-Tech Toilets"
Previous message: Yakov Horenstein: "Re: Service Bureau"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:39:36 EEST