UG to Pro-E translation

From: Georges Fadel (gfadel@ces.clemson.edu)
Date: Tue Apr 01 1997 - 16:39:09 EEST

Next message: Robert Zubrickie: "SLA250 resin removal reply"
Previous message: Andrew Halket: "Re: 3D printing trademark"
Next in thread: Dan Sammons: "Re: UG to Pro-E translation"
Reply: Dan Sammons: "Re: UG to Pro-E translation"
Maybe reply: Paul Lasman: "RE: UG to Pro-E translation"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Whould anyone know of any way to translate UG files to Pro-E?

The IGES translations used just lose all the fillets..

Thanks

---
Georges M. Fadel 
Associate Professor
Mechanical Engineering Department			Tel: (864) 656-5620
Clemson University					Fax: (864) 656-4435
Clemson SC 29634-0921 USA
e-mail: gfadel@eng.clemson.edu
www: http://design.eng.clemson.edu/dmg/people/faculty/fadel.html

Next message: Robert Zubrickie: "SLA250 resin removal reply"
Previous message: Andrew Halket: "Re: 3D printing trademark"
Next in thread: Dan Sammons: "Re: UG to Pro-E translation"
Reply: Dan Sammons: "Re: UG to Pro-E translation"
Maybe reply: Paul Lasman: "RE: UG to Pro-E translation"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:39:27 EEST