Dear Jeffrey,
Care to share the reason you want to build without using the wiper arm?
Best regards,
Marshall Burns
marshall@ennex.com
*************************************************************************
** Ennex(TM) Fabrication Technologies **
** FABRICATING THE FUTURE (TM) **
******* *******
** 10911 Weyburn Avenue, Suite 332, Los Angeles, U.S.A. 90024 **
** Phone: +1 (310) 824-8700 Fax: +1 (310) 824-5185 **
** E-Mail: fabbers@ennex.com **
*************************************************************************
On Wed, 19 Feb 1997, wrana jeffrey scott wrote:
> RP'ers:
>
> I was wanting to build some small parts on an SLA-250 without the use of the
> wiper arm. However, I'm not quite sure how long of a time period to wait
> between the build of each layer. I will be using 5170 epoxy resin.
>
> Does anybody know how long of a time period to wait after the build
> platform has lowered into the vat before the next layer is built to
> insure the liquid level is at steady state (without the use of the wiper arm)?
> If someone has tried it, how were your results?
>
> Any comments would be useful.
>
> Thanks,
> Jeff
>
>
> _________________________________
> Jeffrey S. Wrana
> Graduate Student
> Dept of Bioengineering
> Clemson University
> Clemson, SC 29634
>
>
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:39:21 EEST