Sanders Model Maker can slice and build .0005 inches or 0.012mm.
Rolf Hubert
rhubert@worldnet.att.net
----------
From: owner-rp-ml@bart.lpt.fi on behalf of Chris.B.Clodfelter@REXAM.COM
Sent: Friday, November 22, 1996 4:01 AM
To: rp-ml@cs.hut.fi
Subject: thin layers and manners
Has anyone out there heard of any rp systems that can build a layer
thickness in the 5-10 micron range. Someone at this company remembers
some discussion about ultra thin layers. I have had some success with
.0025" layers with my SLA-250 but anything smaller would be difficult
with my current setup.
I know 5-10 micron layers sounds like a stretch, make that a leap, but
please let me know if anyone has heard of any work or discussions in
this area.
On another matter, I don't see why people feel the need to send a
message to the entire rp-ml to point out a problem with an attached
file. I think most people could see that there was a problem and that
attaching a file doesn't work. A friendly, private reply to the poor
unfortunate soul that had the nerve to make a mistake would probably
suffice.
Building up sure beats tearing down!
C. Clodfelter
Rexam Closures
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:37:45 EEST