Everybody has one (opinion, that is), right?
I have a SLA250 and a FDM1650 with a budget to either set up the SLA
for Quick Cast or outfit the FDM to work in wax. The goal is to be
able to produce patterns for investment casting of aluminum parts.
The most important features of the cast parts will be structural
integrity, followed by precision, with appearance last. Production
runs will be 1 to 10 pieces of each design.
Which route would YOU take, and why?
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:37:42 EEST