Hi everybody
I would just like to say thank you for your response to my question
on Binary to ASCII conversion.
When trying out some of your suggestions I came across a STL to IGES
converter mix in with the partman software. I was wondering if this program
is any good, as I did not know it was there, but it could offer a solution
to the modification of STL file when you get sent the files that need
modification.
I am just curious of peoples experience of this program.
Thanks again
Chris
ainsley@liverpool.ac.uk
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:37:31 EEST