Would any SLS rapid tool users care to comment on the accuracies of this
process when building core and cavity sets in the 8 x 8" range??? An example
of my concerns determining how much finishing time for spotting or finish
machining is required, if any. Is there often the need to fininsh machine
fine detail areas where close tolerances are required or is the process
accurate enough to go straight to benching/polishing?
please send responses to pnrmolds@rust.net.
Thank you!
Ron Ptaszek
P & R Precision, Inc.
50495 Corporate Drive
Shelby Township, MI 48315
tel: 810-254-6720
fax: 810-254-0638
BBS/Modem: 810-254-1664
Email: PnRMolds@rust.net
WWW: http://www.rust.net/~pnrmolds/pnr.htm
"Prototype and Production Injection Molds from 3-D for a Decade, Fast and
Reliable"
******************************************************************************
******
"Flying is simple. You just throw yourself at the ground and miss."
-- D. Adams
******************************************************************************
******
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:37:19 EEST