-- [ From: Al Hastbacka * EMC.Ver #2.10P ] --
Todd Stahlhut wrote:
"Just though I would pass along a helpful trick we have learned here.
In
> the past we would place finished platforms of parts on a tray for
> transport and cleaning. Resin would obviously get all over the tray.
> Cleaning was a hassle and invariably we would clean it in our TPM
tank and
> speed up the saturation of it. What we figure out was to get a large
roll
> of the restaurant plastic wrap and cover the tray. When finished you
can
> just wad or roll it up - pop it in the PCA, then throw away in
normal"
trash.
Does this approach meet the Environmental Protection Agencies rules as
promulgated by the U.S. Government?
Al Hastbacka
-------- REPLY, O
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:37:04 EEST