Honey Extracter

From: Charles Sears (Santin  Engineering, Inc.)
To: RP-ML
Date: Friday, June 9, 1995
From: santin <ir001726@interramp.com>
Subject: Honey Extracter
We have a Dadant Honey Masters extracter with a 62" diameter tank.  We have used 
rubber bands and paper clips to hold parts to the back wall.  Seemed to hold the parts 
well but the pull from the rubber bands can deflect thin walls.  So next we tried putting 
parts in a box surrounded by bunched up newspaper.  This has worked very well since 
we can then cure the paper and the box and dispose of them.  The only problem has 
been that the parts can't get away from the resin thats coming out from the inside to well 
so we end up spending more time cleaning off the outside of the parts than before.  With 
the box method we also had to counter balance the tank.  Hope this helps

Charlie Sears
Santin Engineering
W. Peabody MA
1-508-535-5511
1-508-535-0405 fax
1-508-535-3869 modem

email: santineng@interramp.com